BugZero updated this defect 58 days ago.
Data sources
All data on this page is proprietary to BugZero® or gathered from public sources
3/22/2024
Smart Assurance - SMARTS
No affected releases provided.
No fixed releases provided.
How do I use dmctl to change a Smarts IP PollingInterval setting to a value greater than 3600? How do I change a Smarts IP PollingInterval setting using dmctl? Cannot create a Smarts IP PollingInterval setting greater than 3600 seconds
To change the Smarts IP PollingInterval to a value greater than 3600 using dmctl, do the following:1. Attach to the domain that you would like to change the PollingInterval for using dmctl.2. Run the following command to generate a list of all the Polling Settings for all the different Polling Groups:getInstances Connectivity_Polling_Setting3. Isolate the group that you would like to change the PollingInterval setting as follows:SET-CFG-Polling Groups/[PollingGroup]/Connectivity_Polling_Setting4. Use this [PollingGroup] in the following put command (all on one line) to configure a value greater than 3600 for the PollingInterval (4000 in the following example):put Connectivity_Polling_Setting::"SET-CFG-Polling Groups/[PollingGroup]/Connectivity_Polling_Setting"::PollingInterval 40005. Check the new value of the PollingInterval using the following get command (all on one line):get Connectivity_Polling_Setting::"SET-CFG-Polling Groups/[PollingGroup]/Connectivity_Polling_Setting"::PollingInterval